Make Gas Connection; Electronic Ignition System; Complete Installation; Important - Jenn-Air JGS8850CDB01 Installation Instructions Manual

Use the following chart for correct LP gas orifice spud for each
burner. Refer to the gas information plate on the lower left side of
the front frame for proper sizing of LP gas orifice spuds for each
burner location.
LP Gas Orifice Spud Chart for Model JGS8850
Location Burner Rating Color Number
Right Front 14,000 BTU Red 114L
Right Rear 4,000 BTU Blue 64L
Left Front 13,000 BTU Center: White Center: 55L
Outer: Orange Outer: 97L
Left Rear 9,1 O0 BTU Clear 91L
LP Gas Orifice Spud Chart for Model JGS8750
Location Burner Rating Color Number
Right Front 14,000 BTU Red 114L
Right Rear 9,1 O0 BTU Clear 91L
Left Front 9,1 O0 BTU Clear 91L
Left Rear 4,000 BTU Blue 64L
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart." On dual
burners (on some models), replace the center and outer
spuds.
6. Replace burner base and hand tighten the screws.
7. Place LP burner choke into outer hole of dual burner (on
some models).
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti=tip bracket to rear range foot.
Reconnect the anti=tip bracket, if the range is moved.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1=
2.
Turn manual shutoff valve to the closed position.
Unplug range or disconnect power.
....................................................................... B
A , i
_ .................... C
A. Torange
B. Shutoff valve (closed position)
C. Gas supply line
A. LP burner choke
8. Replace burner cap.
9. Repeat steps 1 through 8 for the remaining burners.
10. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with package containing literature.
11. Replace burner grates.
12. Reinstall storage drawer. See the "Replace Oven Racks and
Storage Drawer" section for instructions.
13. Reinstall oven door. See the "Oven Door" section of the Use
and Care Guide.
14. Complete installation. See "Make Gas Connection" and
"Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
1¼.to _/2" long. The outer cone is not as distinct as the inner
cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
To Convert Gas Pressure Regulator
1. Remove oven racks from inside the oven cavity.
2. Remove the storage drawer. See "Replace Oven Racks and
Storage Drawer" section.
3. Remove the oven door. See "Oven Door" section in the Use
and Care Guide for oven door removal instructions.
4. Using a Phillips screwdriver, remove the 2 oven bake burner
cover screws located at the rear of the oven.
B
A. Oven bake burner cover
B. Oven bake burner cover screws
5. Lift up and remove oven bake burner cover.
6. Remove the 2 oven bake burner screws and set aside.
15