Jenn-Air JGS8850CDB01 Installation Instructions Manual page 13

8=
9=
Locate the access panel at the rear of the storage drawer
compartment. Using a 1¼,, ( 6 mm) nut driver, unscrew the
2 access panel screws. Remove access panel and set aside
along with the 2 screws.
A. Access panel screws
Locate gas pressure regulator at the rear of the storage
drawer compartment.
. _ ._-_]
i
i,
To Convert Oven Bake Burner
1. Locate the oven orificehood from the front of the range.
2. Using an adjustable wrench, turn the Number 49 Natural gas
oven bake burner orifice hood counterclockwise to remove.
© o
IMPORTANT: Do not remove the gas pressure regulator.
10. Unscrew the regulator cap and remove the plastic cover.
3=
A. Number 49 Natural gas oven bake burner orifice hood
Install the Number .0512 LP gas oven bake burner orifice
hood, turning it clockwise 4 or 5 turns. Do not overtighten.
A. Plastic cover
B. Regulator cap
11. Flip the regulator cap over and replace the plastic cover.
A
A. Natural gas position
B. LP gas position
C. Plastic cover
12. Screw the regulator cap securely back into place. Do not
overtighten.
A. Black .0512 LP orifice hood
4. Position the oven bake burner over the oven bake burner
orifice hood and reinstall using 2 screws.
A
A. Oven bake burner
B. Oven bake burner orifice hood
5. Reinstall access panel and oven bake burner cover.
13