Jenn-Air JGS8850CDB01 Installation Instructions Manual page 14

To Convert Oven Broil Burner
1. Remove oven broil burner screw and set aside.
2. Remove the oven broil burner from the oven broil burner
orifice hood. The oven broil burner will hang in the back of the
oven while changing the orifice hood.
6=
Position the oven broil burner against the roof of the oven
cavity and attach with screw.
A B
3=
A. Oven broil burner screw
B. Oven broil burner orifice hood
Turn the Number 52 Natural gas oven broil burner orifice
hood counterclockwise to remove.
C
D
A. Oven broil burner orifice hood
B. Oven broil burner
C. Oven broil burner Iocator pin
D. Oven broil burner Iocator hole
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips screwdriver, remove the burner base.
A
\
4=
/
.... / j
A. Number 52 Natural gas oven broil burner orifice hood
Install the green Number .0430 LP gas oven broil burner
orifice hood, turning it clockwise 4 or 5 turns. Do not
overtighten.
4=
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
Apply masking tape to the end of a 9/32 H (7 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set Natural gas orifice spud aside.
5=
A. Number .0430 LP gas oven broil burner orifice hood
Place the oven broil burner on the oven broil burner orifice
hood. Insert the oven broil burner Iocator pin in the hole in the
oven back.
A B
A. Natural gas orifice spud
B.Dual burner
C. Single burner
C
14