Advertisement
Installing
Side
Panels:
Optional
side panels
need to be 1/4-inch
thick.
Slide panel
into position
and secure
with screws
indicated
by the shaded
area (Fig. 1 la).
A 3/16-inch
batten
is required
between
the cabinet
and side
panel (Fig. 11 b). A 1/2-inch
thick by 10 1/4-inch
tall batten
is required
if the side panel extends
up
into the machine
compartment
area on the
refrigerator
side (Fig. 1 lc).
1/4" side panel fitted up to
the cabinet trim (top view)
on Freezer side,
Backside of Unit
1/2"
Screw
1/4" side panel fitted up to
the cabinet trim (top view)
on Refrigerator
side.
Backside of Unit
#8-32
Screw
Fig. I la
b----...
J
Anchor
the
Unit
(Optional):
If you are attaching
the unit to cabinetry,
drill three 3/16" holes
through
both outer trims. Drill 1/8" pilot holes into the cabinetry.
Install screws.
Additionally:
If the depth/height
of opening
is excessive
use
steel hanger
strap.
Double
over strap
at the achor
points to
secure
cabinet.
Adjust door hinges:
Check to make sure the doors
are properly
adjusted.
If not,
adjust the top hinges.
The hinges
are slotted
for side to side
movement.
Remove
and discard
the small
phillips
screw on
the door hinge, which
is located
on the hinge.
Adjust
the top
hinges
by loosing
the 3 large Torx screws.
Tighten
the screws
after the doors
are adjusted.
Extruded
door handles
can be
adjusted
for alignment
by loosening
the screws
under the
magnetic
backed
molding
(See fig. 8a).
> 3/16"/.48
Battens
112"11.27 Battens
on side of
compartment
(3/16"/,48 below the
machine compartment)
1/4"/.64 Side Panel
1/4"/.64
of Unit
Refrigerator Side of Unit
Door
Door
Fig. lib
Fig. I I c
, Drill 3 holes through
vertical frame into
cabinetry.
Where
applicable.
(approx. location)
111406-1
6
(060402)
Advertisement
