Advertisement
Blocking the Unit:
If there
is a solid soffit above the unit and the clearance
is 1"
or less you will not need to block the unit.
For installations
with
clearances
of more than
1", you must use the anti-tipping
2x4
and brackets
provided
(Fig. 6).
More than
aR 1"
Fig. 6
/
More
than
1" clearance:
Use the anti-tipping
kit provided
with the shipping
crate.
Locate
and
mark the 2 wall studs behind
the unit.
Mark where
the "L" brackets
and 2x4 will be located
and drill 2 pilot holes 1/8". Locate
the proper
height to clear the unit. The space
between
the top of the unit and
bottom
of the wood
block must not exceed
1/4".
Secure
the "L"
brackets,
using the provided
screws,
into the wall studs
(,_1)). Make
sure the screws
will extend
7/8" into the wall studs.
Align
the pilot
holes with the "L" brackets
and secure
the 2x4 with the screws
provided(,_,5_).
-Wall Studs._
I I
i I/
I
I
I
Fi8. 7
Installing Backer Panels:
Remove
the door handle
or trim piece on overlay
models.
A magnetic
backed
molding
hides the handle
or overlay
trim screws.
Use the
adhesive
side of the packaging
tape on the magnetic
backed
molding
to pull it away from door (Fig. 8a).
Remove
the screws
with a
phillips
screwdriver
(Fig. 8b).
Slide the backer
panel into position.
The backer
panel
needs to be under the trim.
Install the handle.
Replace
the molding
in the channel,
and reset the magnetic
backed
molding.
To install the backer
panel
on the grille remove
the screws
on the top and bottom
of the upper cover
(Fig 8c).
DO NOT REMOVE
the foam.
Slide the backer
panel into place and replace
screws
(Fig 8d).
If the thickness
of the backer
panel
is less than a 1/4", back it up with a sheet
of shim material
to obtain
a 1t4" thickness.
Cardboard
is recommended
for Stainless
Steel application.
For panel size refer to Fig. 10.
_&,CAUTION:
Do not drive screws
or sharp
objects
into the doors.
Do not pinch
door
seal when
reinstalling
handle.
Grille Panel
PhillipsScrewdriver
/
Use Tape
to Pul! Magnetic
Molding Away
from Door
Fig. 8a
:!
J
Fig. 8b
r
Fig. 8c
For Screws
_, CAUTION:
When
attaching
a raised
wood
panel of 1/2" or thicker
secure
the
raised
panel to the back of the grille
cover frame.
Use 4 #8 or similar
screws.
See illustration
for approximate
locations.
Advertisement
