Installation Instructions - IKEA GCI3061 Installation Instructions Manual

Ifthehouse h asaluminum w iring, follow theprocedure
below:
1. Connect asection o fsolid copper wire tothepigtail
leads.
2. Connect thealuminum w iring totheadded section o f
copper wire using special connectors and/or tools
designed andULlisted forjoining c opper toaluminum.
Follow theelectrical connector manufacturer's recommended
procedure. Aluminum/copper connection must c onform with
local c odes a ndindustry a ccepted wiring practices.
INSTALLATION INSTRUCTIONS
1. Decide on the final location for the cooktop.
NOTE: Countertop must be 13/16 ' ' (3.0 cm) to 2" (5.1 cm) thick.
2. If necessary, make cutout in countertop before installing
cooktop. See "Location Requirements" section for more
information.
4. Position brackets in the center of the vertical centerline and
align the upper edge of the brackets so that they are flush
with the countertop.
3. Clean cutout of any remaining dust and debris.
_ _ J_ ,,_
NOTE: Kit Part Number W10310006 is required for installing the
cooktop into a solid surface or marble countertop. See the
"Assistance or Service" section of the Use and Care Guide for
information on ordering.
To Install Brackets into Marble Countertop:
1. Clean the brackets and cooktop cutout of any dust and
debris.
2=
3=
Measure the center line of the vertical sides of the cooktop
cutout.
Center line
Apply the adhesive provided in the kit to the back side of the
brackets.
5=
Push the brackets firmly onto each side of the cooktop cutout
and wait 1 hour for adhesive to dry.
To Install Brackets into Wood Countertop:
1. Measure the center line of the vertical sides of the cooktop
cutout.
Center line
2. Position brackets in the center of the vertical centerline and
align the upper edge of the brackets so that they are flush
with the countertop.
3. Attach the brackets in the cutout with the screws provided.
A
B
A. Bracket
B. Screw