Technical Data; Installation - IKEA ELDSLAGA Manual

ENGLISH

Technical data

Dimensions
Width (mm)
Height (mm)
Length (mm)
Voltage (V)
The technical information are situated in the
rating plate on the bottom side of the
appliance.

Installation

After unpacking the hob, make sure that it
has not been damaged during transport. In
the event of problems, contact the dealer or
your nearest After-sales Service.
Technical information for the installer
- This product can be embedded in a
worktop 20 to 50 mm thick.
- If there is no oven beneath the hob,
insert a separator panel that has a
surface at least equal to the opening
in the work surface. This panel must be
positioned in no case less than 20 mm
from the bottom of the hob.
- Before installation, make sure that:
- the local gas delivery conditions (nature
and pressure) are compatible with the
settings of the hob (see the rating plate
and injector table);
- the outer surfaces of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulations;
- This appliance is not connected to a
730
40
510
220 - 240
fume exhaust device. It shall be installed
in accordance with current installation
regulations. Particular attention shall
be given to the relevant requirement
regarding ventilation.
- Combustion products are discharged
and/or window mounted electrical fans.
Gas connection
This operation must be performed by a
The gas supply system must comply with
local regulations to the relavant gas
standard.
-
for some countries in the paragraph
"Reference to Local Regulations". If no
information concerning your Country is
technician.
- The connection of the hob to the gas
pipe network or gas cylinder must be
12