Maintenance And Troubleshooting - Weslo Pursuit R 2.2 Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace the bat-
teries; most console problems are the result of low
batteries. To replace the batteries, see assembly step 5
on page 8.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 4 on page 13.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the left pedal and the left shield must be
removed.
Using an adjustable wrench, turn the left pedal clock-
wise and remove it. Next, remove all of the screws
from both shields; there are two sizes of screws in
the shields—note which size of screw you remove
from each hole. Then, carefully remove the left shield.
Next, turn the resistance knob to the lowest setting.
Locate the Reed Switch (39). Turn the Crank (21) until
a Magnet (38) is aligned with the Reed Switch. Loosen,
but do not remove, the #8 x 16mm Screw (41).
38
39
41
Next, slide the Reed Switch (39) slightly closer to or
away from the Magnet (38), and then retighten the #8
x 16mm Screw (41). Turn the Crank (21) for a moment.
Repeat these actions until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the shields and the left pedal.
15
21