Date & Time Set Procedure; Applying The Cuff - HoMedics BPW-201 Instruction Book

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the top of the monitor.
2. The display will show a blinking number showing
the HOUR. Change the HOUR by pressing the
button. Each press will increase the number
by one in a cycling manner. Press the Set button
again to confirm the entry, and the screen
will show a blinking number representing the
MINUTE.
3. Change the MINUTE, MONTH, DAY and YEAR as
described in Step 2 above, using the
to change the numbers and the Set button
to confirm the entries.
AVG. 3
repeat process to set MINUTE,
MONTH, DAY and YEAR
button
Press the button
AVG. 3
blinking HOUR
increasing HOUR
confirm the entry
17

APPLYING THE CUFF

1. Remove all watches, wrist jewelry, etc. prior to
attaching the wrist monitor. Clothing sleeves
should be rolled up and the cuff should
be wrapped around bare skin for correct
measurements.
2. Apply cuff to left wrist with
palm facing up as shown in
Fig. A.
3. Make sure the edge of the
cuff is about 1/4"~1/2" (1 cm)
from the palm as shown in
Fig. B.
Fig. A
Fig. B
18