Diamondback 510Ic Owner's Manual page 13

• Locate connector (B-13) exi ng the
bo om of the handlebar assembly (B).
• Connect (B-13) to wire harness connector
G-9, taking care to ensure the connec on
is fi rm.
• Feed excess cable into mast.
• Remove handlebar assembly endcap fi xing screw (B-4) from the handlebar assembly
endcap (B-1).
• Insert the handlebar assembly endcap (B-1) into the bo om of the handlebar assembly
(B).
• Reinstall the handlebar assembly endcap fi xing screw (B-4) through the base of the
handlebar assembly (B) to secure the endcap.
• Take care not to pinch wire.
11
510Ic Owner's Manu
ASSEMBLY INSTRUCTIONS
al