510Ic Assembly Instructions - Diamondback 510Ic Owner's Manual

ASSEMBLY INSTRUCTIONS
• Unpack the 510Ic from the carton. Please recycle.
• Verify the carton contains all parts from the list.
• Using the 6mm allen wrench, remove the blocking (the short
sec on of tubing installed at the factory to prevent damage to the
front frame during shipping) by removing the two fi xing screws
shown in Figure 1 above.
• Discard this piece.
• Align the front stabilizer (D) with the receiver located in the front
of the frame, and loosely install four (4) H-1 bolts, two (2) curved
washers (H-2) and two (2) fl at washers (H-3), making sure that
the correct shape of washers are installed on their corresponding
surface profi le; i.e. fl at washer on the fl at surface, etc. When all
bolts have been inserted, ghten for fi nal installa on with the
6mm allen wrench.
• Repeat this process for the rear stabilizer assembly (C).
8