Reset Button; Factory Defaults Button - NETGEAR ProSafe GS108T Hardware Installation Manual

GS108T Hardware Installation Guide

Reset Button

The Smart Switch has a Reset button on the front panel to allow you to manually reboot the switch.
This action is equivalent to powering the unit off and back on. The last saved configuration is
loaded into the switch as it resets. To operate the Reset button, insert a device such as a paper clip
into the opening to press the recessed button. The front-panel LEDs should extinguish and light
again as the switch performs its Power On Self Test (POST).

Factory Defaults Button

The Smart Switch has a Factory Defaults button on the front panel so that you can remove the
current configuration and return the device to its factory settings. When you enable the Factory
Defaults button, all settings, including the password, VLAN settings, and port configurations will
be set to the factory default values. To operate the Factory Defaults button, insert a device such as
a paper clip into the opening to press the recessed button for at least two seconds.
2-4 Physical Description
v1.0, January 2010