Specifications - Tripp Lite SMART500RT1U Owner's Manual

Specifications

The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
Model: SMART500RT1U
Series #: AGSM52SRM1U
Input
Nominal Voltage/Frequency: 120VAC/60 Hz
Recommended Dedicated
Electrical Circuit:
Output
Capacity (VA/Watts):
On Line Nominal Voltage/Waveform: 120VAC/sine wave
On Battery Nominal
Voltage/Waveform: 115VAC/PWM sine wave
Battery Runtime
(Half Load/Full Load) Minutes*:
Battery Recharge Time*:
FCC:
Approvals: UL, cUL, NOM
Model: SMART1500RM2U
Series #: AGSU1522U31
Input
Nominal Voltage/Frequency: 120VAC/60 Hz
Recommended Dedicated
Electrical Circuit: 15 amp
Output
Capacity (VA/Watts): 1500/1000
On Line Nominal
Voltage/Waveform: 120VAC/sine wave
On Battery Nominal
Voltage/Waveform: 120VAC/sine wave
Battery Runtime (Half Load/
Full Load) Minutes*: 25/10
Battery Recharge Time*: 2-4 hrs.
FCC: Class B
Approvals: UL, cUL, NOM
ALL UNITS: Voltage-Regulated Output Voltage Range: ± 9%. On-Battery Output Voltage Range: ± 5 %. AC Surge Suppression (exceeds IEEE 587 Cat. A & B standards); AC Noise Attenuation (>40
dB at 1MHz); AC Protection Modes (H to N, H to G, N to G).
+ Battery runtime can be extended with addition of optional Tripp Lite External Battery Packs (sold separately). SMART1500RMXL2Ua models use BP36V15-2U battery packs (limit one; not daisy-
chain capable). SMART2200RMXL2U, SMART2600RM2U and SMART3000RM2U models can use either BP48V24-2U (limit one; not daisy-chain capable) or BP48V60RT3U (daisy-chain capable)
battery packs. External batteries will increase both the battery runtime and the battery recharge time.
* Since these models include two plug options, the amperage of the recommended circuit would change to match the amperage of the plug. The output capacity would also change based on the plug
type used. SMART2200RMXL2U features a 20-amp NEMA 5-20P plug attached to its line cord, but includes a 15-amp NEMA 5-15P plug loose in the box that can be attached to the line cord by a
qualified electrician. SMART2600RM2U features a 20-amp NEMA 5-20P plug attached to its line cord, but includes a 30-amp twist-lock NEMA L5-30P plug loose in the box that can be attached to the
line cord by a qualified electrician. SMART3000RM2U features a 30-amp twist-lock NEMA L5-30P plug attached to its line cord, but includes a 20-amp NEMA 5-20P plug loose in the box that can be
attached to the line cord by a qualified electrician.
FCC RADIO/TV INTERFERENCE NOTICE: (FOR CLASS A MODELS)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with
the instruction manual, may cause interference to radio communications. Operation of this equipment is likely to cause harmful interference in which case the user will be required to correct the interference
at his own expense. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC RADIO/TV INTERFERENCE NOTICE: (FOR CLASS B MODELS)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual,
may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference using one or more of the following measures: reorient or relocate
the receiving antenna; increase the separation between the equipment and the receiver; connect the equipment into an outlet on a circuit different from that which the receiver is connected; consult
the dealer or an experienced radio/television technician for help. The user must use shielded cables and connectors with this product. Any changes or modifications to this product not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
SMART750RM1U
AGSM7501UPC
120VAC/60 Hz
15 amp 15 amp
500/300 750/450
120VAC/sine wave
120VAC/sine wave
14/4 24/7
2-4 hrs. 2-4 hrs.
Class B Class A
UL, cUL, NOM
SMART1500RMXL2Ua SMART2200RMXL2U
AGSU152XU31 AGSU2222U31
120VAC/60 Hz 120VAC/60 Hz
15 amp 20 amp or 15 amp*
1500/1000 2200/1600 *
(with 20 amp plug)
1440/1307 *
(with 15 amp plug)
120VAC/sine wave 120VAC/sine wave
120VAC/sine wave 120VAC/sine wave
25/10+
2-4 hrs.
Class B
UL, cUL, NOM UL, cUL, NOM
13
SMART1000RM1U
AGSM10001UPC
120VAC/60 Hz
15 amp
1000/640
120VAC/sine wave
120VAC/sine wave
25/10
2-4 hrs.
Class A
UL, cUL, NOM
SMART2600RM2U
AGSU3022U31
120VAC/60 Hz
30 amp or 20 amp*
2600/2100
(with 30 amp plug)
2200/1787
(with 20 amp plug)
120VAC/sine wave
120VAC/sine wave
20/8+ 18/6+
2-4 hrs. 2-4 hrs.
Class A Class A
UL, cUL, NOM
SMART1000RM2U
AGSU1022U31
120VAC/60 Hz
15 amp
1000/700
120VAC/sine wave
120VAC/sine wave
21/9
2-4 hrs.
Class B
UL, cUL, NOM
SMART3000RM2U
AGSU3022U31
120VAC/60 Hz
30 amp or 20 amp*
3000/2250
(with 30 amp plug)*
2200/1787
(with 20 amp plug)*
120VAC/sine wave
120VAC/sine wave
13/4+
2-4 hrs.
Class A
UL, cUL, NOM