Mounting - Tripp Lite SmartPro Owner's Manual

200503166 93-2406 Sinewave SmartPro Rackmount UPS OM.qxd
Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure (see next page for 2-post
mounting). The user must determine the fitness of hardware and procedures before mounting. If
hardware and procedures are not suitable for your application, contact the manufacturer of your rack
or rack enclosure. The procedures described in this manual are for common rack and rack enclosure
types and may not be appropriate for all applications.
4-Post Mounting
All UPS models include hardware required to mount in a 4-post rack. Select models include an
adjustable rackmount shelf kit to provide additional support. If your UPS model does not include
an adjustable rackmount shelf kit, skip steps 1 and 2.
1
Connect the two segments of each shelf
included screws and nuts
loose so that the shelves can be adjusted in the next step.
Adjust each shelf to fit your rack, then mount them in
2
the lowest available space of your rack with the
screws, nuts and washers provided
support ledges should face inward. Tighten the screws
that connect the shelf segments
Attach mounting ears
3
of your equipment
The ears should face forward.
Using an assistant if necessary, lift your equipment
4
and slide it onto the mounting shelves. Attach your
equipment to the rack by using the appropriate
hardware G through its mounting ears and into the
rack rails.
A using the
B . Leave the screws slightly
C . Note that the
.
B
D to the front mounting holes
E using the screws provided
3
3/29/2005
B
A
1
C
2
.
F
E
D
3
G
4
3:12 PM Page 3
B
F