Installation and Wiring
Step 3: Mount the Speaker Into the Wall
Push the speaker into the hole until the front baffle rim is flush with the
wall. Tighten the mounting tabs by turning the screw clockwise until the
speaker is secure. Please note that the first clockwise quarterturn rotates
the attachment tabs outward. The remaining turns tighten the tabs down
onto the back of the wall (see Figure 10).
Figure 9:
Figure 10:
Mount Speaker Into Wall
Tighten Mounting Tabs
INSTALLATION NOTE: MOUNTING TABS
For each attachment screw, first turn one halfturn counterclockwise to
release the mounting tab from its guide.
Step 4: Adjust Tap Selector
The tap selector switch is located on the front baffle. Adjust the speak-
er to the appropriate tap setting before installing the grille. In some
70V/100V constant voltage installations it is advisable to leave the grilles
off if final speaker audio level balance adjustments are to be made later.
After the levels are adjusted the grilles can then be installed.
Figure 11:
Adjust Tap Selector (Left: FM4.2, Right: FM6.2)
8
EVID™ FM Series Installation and Operation Manual