Step 4: Mount The Speaker To The Quicksam™ Bracket - Electro-Voice Zx1i-100 Owner's Manual

Step 4: Attach the Speaker to the QuickSAM™ Bracket
After mounting the QuickSAM
speaker to the QuickSAM
the speaker until it "clicks" in place. Using the provided mounting tool, tighten the two
socket head bolts A and B enough to allow aiming, as shown in Figure 9. After selecting
the proper horizontal angle, secure the sweep axis as shown by tightening bolt A. Next,
select the proper vertical angle and secure the rotation axis by tightening bolt B. To
tighten the recessed bolt B, insert mounting tool through hole on the side of the speaker.
Figure 9: Attaching Speaker to QuickSAM
8
TM
bracket (from Step 1) to the desired surface, attach the
TM
bracket by inserting the QuickSAM
WARNING: Bolt "B" is what secures the speaker to the
TM
QuickSAM Bracket. It is the installer's responsibility to
ensure that Bolt "B" is fully tightened. Failure to tighten Bolt
"B" may allow the speaker to disengage from the
TM
QuickSAM Bracket, possibly resulting in serious injury. Use
of the Seismic restraint is highly recommended. See Step 6.
Enclosure
®
Electro-Voice
TM
into slot on the side of
Socket Head
Bolt A
QuickSAM
Assembly
Mounting Tab
Socket Head Bolt B
(Recessed Inside
Hole)
TM
Assembly
Zx1i Owner's Manual
TM