8. All instructions concerning the handling of MOS - circuits have to be observed. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. SxA360 Owners Manual...
· Check that the speaker stand is placed on a flat, stable surface and be sure to fully extend the legs of the stand. Do not try to make the stand “taller” and compromise its structural integrity.
· The separate line output is 3-pin XLR-type balanced, low-impedance output that can be used with long cable runs. · The SxA360 two-way system is perfect for use as powered floor monitors. System Setup To get your SxA system into operation as quickly as possible, please observe the following steps and precautions.
Setup Diagrams for SxA360 · Plug a line input into either the ¼-inch or the 3-pin XLR-type input connector. Examples of line input sources are mixer outputs, CD/DVD players, cassette decks, VCRs, electronic keyboards, computer sound cards, etc. The ¼- inch input is in the center of the XLR connector and can accept unbalanced or balanced lines (TRS ¼-inch).
· The SxA360 is perfect for use as a powered floor monitor. · The F200 adapters are necessary to convert the SxA360 into a monitor and are shipped with the speaker. To install the adapters, simply insert them into the speaker (See Figure 2 below). The F200 adapters can be easily removed by pulling in the opposite direction.