Meter Status Display; Parameter Setting Procedure - Fostex FM-4 Owner's Manual

(3) While the THRE value ("
(" ") is flashing, use the [+] or [-] key to
select the desired value .
You can set the THRE value to "
" ", while you can set the RATIO value to "
or " " .
To select the threshold value:
Flashing
Press the [+] key
Flashing
Press the [+] key
Flashing
Flashing
Press the [+] key
Flashing
(4) After selecting the desired value, press the
[EDIT] long enough to stop flashing .
(5) Press the [EDIT] key to exit the status display
mode .
<Memo>: The limiter parameter setting re-
mains even after you turn off the unit . If you
initialize the flash memory using the system
status display, it is reset to the default setting
(see page 24) .
") or the RATIO
", "
Press the [-] key
Press the [-] key
To select the ratio:
Press the [-] key
" or
On the meter status display, not only you can see the
"
current status of the metering, but also you can set
parameters . The following shows the default setting
when the unit is shipped .
(1) Peak meter ON/OFF
You can enable or disable the peak meter function for the left and right
channels independently .
(2) VU meter reference (0 VU) level
You can set the reference level for the left and right channels indepen-
dently .
(3) Threshold level of the peak over indicator
You can set the peak threshold level for the left and right channels
independently .
(4) Internal battery type
You can set the battery type between alkaline or nickel hydride .

Parameter setting procedure

(1) While the meter status display is shown,
press the [EDIT] key long enough .
The peak meter on/off setting of the left channel ("
") starts flashing . You can now edit the peak
meter on/off setting of the left channel .
<Memo>: By bringing up the meter status
display while the unit is receiving a signal, you
can edit parameters while checking move-
ment of the VU and peak meters .
(2) While any parameter is flashing, press the
[EDIT] key to select the flashing parameter .
Pressing the [EDIT] key selects the flashing pa-
rameter in the following order .
Lch "PK"
BAT TYPE


Meter status display

Flashing
Lch "0VU"
Rch "OVR"
Lch "OVR"
Rch "PK"
Rch "0VU"