Selecting the meter mode
You can select the meter mode from stereo, mono
L and mono R . By default, it is set to the stereo
mode .
The meter mode setting remains even after you
turn off the unit . If you initialize the flash memory
using the system status display, it is reset to the
default setting (see page 24) .
(1)
Press the [METER] key long enough to enter
the meter select mode .
The meter mode icon is shown at the bottom of the
display .
<Memo>: If you do not press any key for ap-
proximately five seconds while the meter mode
icon is shown, the icon automatically disap-
pears and the unit exits the meter select mode .
(2)
Press the [+] or [-] key to select the desired
meter mode .
Press the [-] key
Mono meter (L) mode
Press the [-] key
Mono meter (R) mode
(3)
Immediately after selecting the desired meter
mode, press the [EDIT] key to exit the meter
select mode .
Stereo meter mode
Press the [+] key
Press the [+] key
Selecting the status display
In the status display mode, not only you can check
the status for the input, output, meter and system,
but also you can edit setting .
(1)
Press the [STATUS] key long enough to enter
the status display mode .
The display shows the input status display .
(2)
Press the [+] or [-] key to select the desired
status display .
Press the [-] key
Press the [-] key
Press the [-] key
(3)
Press the [EDIT] key to exit the status display
mode .
For details about the contents of each status dis-
play and parameter setting, see the next page .
1
Input status display
Press the [+] key
Output status display
Press the [+] key
Meter status display
Press the [+] key
System status display