User Test Print Mode - Oki LD610 T User's Technical Reference

Section 3: Operation and Configuration

3.3 USER TEST PRINT MODE

This mode produces test labels for diagnostic purposes.
Preparation:
Make sure the media or ribbon (if required) are properly loaded in the printer.
Procedures
1
While pressing
FEED/LINE button, press
and release POWER
button. Keep holding
FEED/LINE button.
2
Release FEED/LINE
button when ON LINE
(POWER) indicator
changes to green light
and single short beep
sound is heard.
(The printer will cyclically
advance to next mode as
long as the FEED/LINE
button is held down.)
3
Press FEED/LINE button
to start test printing.
Press FEED/LINE button
to pause the test printing.
Press again to resume.
Notes:
• If you missed the chance to release the FEED/LINE button in step 2 above, just keep holding the
FEED/LINE button and wait for the next cycle.
• If you released the FEED/LINE button at the wrong ON LINE (POWER) or ERROR indicators, just turn off
the power and restart the procedure.
• The printer will continuously print the user test labels until the FEED/LINE button is pressed. The printing is
paused and will resume printing if the FEED/LINE button is press again.
To terminate the User Test Print mode
First, ensure that you have pressed the FEED/LINE button to pause the test printing, then press POWER to
turn off the printer.
Page 3-4
Printer status
Printer start-up
User Test Print mode.
FEED/LINE
released
User Test Print mode
is activated and then
paused.
User Test Print start
and print continuously.
User Test Print paused.
ON LINE (POWER)
indicator
Red light
Off
Green light Off
Off
Blinking green light
Off
Green light
Off
Blinking green light
LD610 User's Technical Reference
ERROR
Buzzer
indicator
One short
beep