Loading Labels - Oki LD610 T User's Technical Reference

2.3 LOADING LABELS

2.3.1 Loading Roll media
1.
With the power supply off, pull the cover open/close
1
latches on both sides of the printer toward you to
unlock the top cover, and then open the top cover
Note:
Make sure that the cover rests firmly so that it will not fall
forward and injure your hands.
2.
While holding the media guide slide lever, adjust the
width of the media holder
3.
Load the media onto the media holder.
4.
After pulling out the media, pass the media through the
media guides and place the leading edge of the media
on top of the platen roller.
Note:
Make sure the printed side of the media is facing
upwards.
LD610 User's Technical Reference
1
to match the media size.
2
.
1
Media guides
Printed side should face
upwards
Section 2: Installation
1
2
1
Media guide
slide lever
Page 2-3