Offset Position Adjustment - Oki LD610 T User's Technical Reference

8.6 OFFSET POSITION ADJUSTMENT

This setting adjusts the option (Cutter, Dispenser, Tear off) stop position after a print out.
The Offset position can be adjusted by using OKI Utilities Tool application or by sending command <PO> from
the host. The setting range is within ±99 dots. A positive value moves the leading edge of the label forward
(away from the print head) while a negative value moves the leading edge of the label back toward the
mechanism.
Adjustment for
LD610 User's Technical Reference
Adjustment of Offset setting
Label feed direction
"+" direction
No
Adjustment
Adjustment for
"-" direction
Stop position for
cutting,dispense
Base reference
or tear-off
position for printing
+99 (dot) -99 (dot)
Section 8: Appendix
Page 8-9