Operating Modes - Oki LD610 T User's Technical Reference

3.2 OPERATING MODES

You can set the printer in any of the following modes:
1.
Normal mode (including Online/Offline modes)
2.
User Test print mode
3.
Factory Test print mode
4.
Operation Setting mode:
• Program download mode
• Font download mode
• Default setting mode
• HEX Dump mode
• USB interface
• RS-232C/ LAN/ IEEE 1284 interface
• Keypad selection
• Scanner, Smart keyboard
You can access the modes by pressing and releasing the POWER button and the FEED/LINE button at
particular points during the ON LINE (POWER) and ERROR indicators' lighting sequence.
The following flow chart provides a clear summary of each of the modes and its access method.
Procedures
Power off
Press POWER
button
While pressing
FEED/LINE button,
press POWER button
LED indicator symbols
: Off
: Red light
: Green light
LD610 User's Technical Reference
Operating Mode
Printer Start up
Normal Mode
(Online)
Release POWER button and
keep holding FEED/LINE
button until the desired mode
lighting pattern is shown.
Printer Start up
User Test Print
Mode
Holding
FEED/LINE
button
Factory Test
Print Mode
Holding
FEED/LINE
button
Operation setting
Mode
Holding
FEED/LINE
button
Section 3: Operation and Configuration
LED indicator responses
ON LINE (POWER)
Off Red light
Green light Off
Off Red light
Green light
Off
Red light
Off
Blinking green light
Off
ERROR Buzzer
One short beep
One
short beep
Two
short beeps
Three
short beeps
Page 3-3