Assembly Instructions; Attaching The Locking Arm Mechanism - Fitness Quest AB LOUNGE XL Owner's Manual

Occasionally our products contain components that are pre-lubricated at the factory. We recommend
that you protect flooring, or anything else the parts may contact, with newspaper or cloth.
X15908-1
Handlebar with Locking Knob
X15906
Foot Rest Assembly
X15901-8
Locking Arm
X15901-1
Front
Frame

ASSEMBLY INSTRUCTIONS

NOTE: All location references, such as front, rear, left
or right, made in these instructions are from the user
sitting on the unit and facing forward.
Main Assembly
Step 1.
Remove the Main Assembly and all parts from packing
and place them on floor as shown in Figure 1.

Attaching the Locking Arm Mechanism

X15901-2
Rear Frame
FIGURE 2
--------
X15901
Pin
X15901-8
Locking Arm Step 2. Lift and place the unit on its
Mechanism
right side with the left side and Locking
Arm facing up as shown in Figure 2.
Open the unit by grasping the bottom of
the Front and Rear Frames and spread
them apart.
Swing the Locking Arm, located on the
Left Front Frame, around so the notch
lines up with the pin on the Left Rear
Frame. Push down on the button on
the Locking Arm Mechanism and slide
it back while you hook the notch over
the pin.
--------
5
FIGURE 1
X15908-7
Long Band
X15908-8
Short Band