Starting The Fireplace - Display Panel; Fireplace Operation Sequence - Empire Comfort Systems FG28BM Series Owner's Manual

Starting the Fireplace – Display Panel
If the remote control is inoperable due to being damaged or having
dead batteries, the fireplace's display panel may be used to oper-
ate the fireplace instead.
Note:
When operating the fireplace manually from the
display panel, only basic operations are available: On, off and
flame level adjustment.
1. To operate the fireplace manually, press the "Mode Select"
button on the display panel until a number appears in the
"Flame Level" location on the display panel. The fireplace will
begin the start up sequence.
MODE
SELECT
REMOTE
MANUAL
OFF
BLOWER
SPEED
DISPLAY
Mantis
BACK LIGHT
Note: The start up sequence takes approximately 1 minute,
15 seconds to complete.
2. Use the "UP" and "DOWN" buttons on the right of the display
panel to adjust the desired flame level.
MODE
SELECT
REMOTE
MANUAL
OFF
BLOWER
SPEED
DISPLAY
Mantis
BACK LIGHT
Page 10
UP
SET
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN
UP
SET
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN
Fireplace Operations Sequence
1. When the main power switch is turned on, the red and green
control board LED's will begin to flash alternately while the
remote receiver searches for the remote transmitter's signal.
Each light will pulse four times then the fireplace will enter
standby mode. While in standby mode, the green LED will
flash slowly and the display panel will shown a double dash
"- -".
RED LED
GREEN LED
YELLOW LED
29432-1-0512