Table of Contents
Advertisement
19
Hardware Setup
J2 – PS/2 Mouse Connector
Attach PS/2 mouse cable to this connector.
J22 – Turbo LED Connector
Attach the turbo LED to J22. The LED lights when the system is in
Turbo mode.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach on-board hard disk drives to these connectors.
J11 – HDD LED Connectors
Attach on-board hard disk drive LEDs to this connector. The LED lights
when an HDD is active.
COM/VGA/LINE Connectors
Attach COM1/COM2/VGA/LINE OUT adapter to these connectors.
FDC1 Connector
Attach floppy cable to this connector.
P1 – Parallel Port Connector
Attach parallel port cable to this connector.
J3 – Pipelined Burst SRAM Module Slot
Contact your supplier for Pipelined Burst SRAM upgrade module to
upgrade your on-board cache SRAM up to 512KB. Make sure JP31 is
set for the right size when you upgrade your cache SRAM.
Advertisement
Table of Contents
