Agilent Technologies 2000 X-Series User Manual page 85

Agilent InfiniiVision 2000 X-Series Oscilloscopes
User's Guide
6
Digital Channels
To connect the digital probes to the device under test
Acquiring waveforms using the digital channels
To display digital channels using AutoScale
Interpreting the digital waveform display
To switch all digital channels on or off
To switch groups of channels on or off
To switch a single channel on or off
To change the displayed size of the digital channels
To reposition a digital channel
To change the logic threshold for digital channels
To display digital channels as a bus
Digital channel signal fidelity: Probe impedance and grounding
To replace digital probe leads
This chapter describes how to use the digital channels of a Mixed- Signal
Oscilloscope (MSO).
The digital channels are enabled on MSOX2000 X- Series models and
DSOX2000 X- Series models that have the DSOX2MSO upgrade license
installed.
Digital channels and serial decode cannot be on at the same time. The
[Serial] key takes precedence over the [Digital] key. Serial triggers can be
used when digital channels are on.
93
102
s1
86
89
89
90
92
92
92
91
92
94
97
85