Agilent Technologies 2000 X-Series User Manual page 35

12.
13.
14.
15.
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
Measure The measure controls consist of:
controls • Cursors knob — Push this knob select cursors from a popup menu.
Then, after the popup menu closes (either by timeout or by pushing
the knob again), rotate the knob to adjust the selected cursor
position.
• [Cursors] key — Press this key to open a menu that lets you select
the cursors mode and source.
• [Meas] key — Press this key to access a set of predefined
measurements. See
179.
Waveform keys The [Acquire] key lets you select Normal, Peak Detect, Averaging, or
High Resolution acquisition modes (see
Mode"
Segmented Memory"
The [Display] key lets you access the menu where you can enable
persistence (see
display, and adjust the display grid (graticule) intensity (see
the grid intensity"
File keys Press the [Save/Recall] key to save or recall a waveform or setup. See
Chapter
The [Print] key opens the Print Configuration Menu so you can print the
displayed waveforms. See
239.
[Help] key Opens the Help Menu where you can display overview help topics and
select the Language. See also
page 42.
Chapter 14, "Measurements," starting on page
on page 159) and use segmented memory (see
on page 165).
"To set or clear persistence"
on page 115).
18, "Save/Recall (Setups, Screens, Data)," starting on page 227.
Chapter
"Access the Built-In Quick Help"
Getting Started
"Selecting the Acquisition
"Acquiring to
on page 113), clear the
"To adjust
19, "Print (Screens)," starting on page
1
on
35