The Usb Transceiver And Pairing P7 - Turtle Beach Earforce Z300 User Manual

The USB Transceiver and Pairing
About the USB Transceiver
The USB transceiver sends game audio and chat between your PC and your Z300 headset via digital radio frequency (RF)
signal, so a direct line of sight is not required. When you're out of range, you may hear popping or clicking sounds and
experience audio dropouts if the headset loses the RF signal.
Procedure for Pairing
Your Z300 headset is shipped from the factory already paired with its USB transceiver. When the headset and USB transceiver
are communicating, the pairing indicator LED on the USB transceiver will stay on. If this LED is instead pulsing slowly or off, it
means the USB transceiver can't communicate with the headset. This could happen if the headset is turned off or out of range.
If the LED is pulsing slowly when the headset is on and within range, then they might need to be "paired" as described below:
1
Place the headset around two feet from the USB Transceiver.
2
Make sure the headset is off by pressing the Power button until the Z300 announces "Powering Off."
3
Press and hold the headset Power button for several seconds until the Z300 announces "Pairing Headset."
A
Go to Table of Contents
5 seconds
7