Remote Control - Dimplex DF3003 Owner's Manual

Figure 5
Level 1 Indicator
Level 2 Indicator
Level 3 Indicator
Level 1: The flame effect is turned on and the first red indicator light
illuminates.
Level 2:
The flame effect remains on, the heater is activated to
the low heat setting, and the first and second red indicator lights
illuminate.
Level 3:
The flame effect remains on, the heater is set to the high heat
setting, and all three red indicators
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the heater
off and it will not come back on without being reset. It can be reset by
switching the Main ON/OFF Switch to OFF and waiting five (5) minutes
before switching the unit back on.
CAUTION: If you need to continuously reset the heater, unplug the
unit and call Dimplex North America Limited at 1-888-346-7539.

Remote Control

The fireplace is supplied with a radio frequency remote control. This
remote control has a range of approximately 50 feet (15.25 m), it
does not have to be pointed at the fireplace and can pass through
most obstacles (including walls). It is supplied with one of 2,178
independent frequencies to prevent interference with other units. The
frequency designation is indicated on the back of the transmitter.
Remote Control Initialization
Follow steps 1 through 6 to initialize your fireplace for the first time.
This procedure is also required every time there is a loss of power to
the remote control in the fireplace (I.E. power failure, breaker tripped,
main power switch is turned off).
illuminate.
12