Receiver Controls And Functions; Audio Output Jack - Audio Technica Pro Series 3 Installation And Operation Manual

Receiver Controls and Functions

1a
Figure A — Front Panel Controls and Functions
1. ANTENNAS: Position the "signal" antenna (1a) and
"ground" antenna (1b) as shown to the right and above right. Fully
extend both antennas by pulling on the endcaps.
2. POWER INDICATOR: Lights when power is supplied to
the receiver.
3. RF INDICATOR: Lights to show presence of transmitter signal.
4. AF PEAK INDICATOR: Only lights when audio distortion
is present at maximum modulation. Not affected by
position of Volume control.
Figure B — Rear Panel Controls and Functions

1. AUDIO OUTPUT JACK:

/ " TS (Tip-Sleeve) or "mono"
1
4
phone jack. Use a shielded cable to connect to an
unbalanced aux-level input of a mixer or amplifier.
2. VOLUME CONTROL: Adjusts the audio level at the
output jack. Does not affect AF Peak indicator.
3. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
4. POWER INPUT JACK: Connect the DC plug from the
included AC adapter.
2 3 4
1 2
/ "
1
4
Pro Series 3 Installation and Operation
1b
3 4
3