Advertisement
Receiver Controls and Functions
1a
Figure A — Front Panel Controls and Functions
1. ANTENNAS: Position the "signal" antenna (1a) and
"ground" antenna (1b) as shown to the right and above right. Fully
extend both antennas by pulling on the endcaps.
2. RF INDICATOR: Lights to show presence of transmitter signal.
3. CHANNEL SELECT BUTTON: Soft-touch button selects channel.
4. CHANNEL INDICATOR LIGHTS: Lights to show which channel is
selected. A channel indicator LED will light when power is applied
to the receiver.
5. AF PEAK INDICATOR: Only lights when audio distortion
is present at maximum modulation. Not affected by
position of Volume control.
Figure B — Rear Panel Controls and Functions
1. SQUELCH CONTROL: Adjusts level of noise-muting circuit
(preset at factory but can be adjusted as circumstances warrant).
2. VOLUME CONTROL: Adjusts the audio level at the
output jacks. Does not affect AF Peak indicator.
3. UNBALANCED AUDIO OUTPUT JACK:
phone jack. Use a shielded cable to connect to an unbalanced
aux-level input of a mixer or amplifier.
4. BALANCED AUDIO OUTPUT JACK: XLRM-type connector. A
standard 2-conductor shielded cable can be used to connect the
receiver output to a balanced microphone-level input on a mixer or
integrated amplifier.
5. POWER INPUT JACK: Connect the DC plug from the
included AC adapter.
6. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
2
3
4
5
1
2
3
4
SYSTEM
9
RF
PEAK
CHANNEL
1
2
3
MIN.
MAX.
MIN.
MAX.
SQUELCH
VOLUME
UNBALANCED
/
" and XLRM
1
4
/
" TS (Tip-Sleeve) or "mono"
1
4
System 9 Installation and Operation
1b
4
5
6
DC 12V IN
BALANCED
500mA
1
2
3
4
SYSTEM
9
CHANNEL
1
2
3
4
SYSTEM
9
CHANNEL
3
Advertisement
