Inbound Filter - D-Link DWR-116 User Manual

Section 3 - Configuration
Inbound.Filter enables you to control what packets are allowed
to pass through the router. Inbound filter only applies to packets
that are destined for Virtual Servers or DMZ hosts.

Inbound Filter:

Select this box to Enable the filter.
Use Schedule You may select Always. On or choose the
Rule: number of a schedule rule that you have
defined.
Copy to ID: Copies the predefined filter to the specified ID
ID: Identifies the filter.
Source IP : Specify the local IP address
Source Ports: Specify the local port after the colon.
Destination IP : Specify the remote IP address
Destination Ports: Specify the remote port after the colon.
Enable: Select this box to enable the filter.
Schedule Rule #: Specify the schedule rule number.
Previous Page: Go back to the previous filter page.
Next Page: Advance to the next filter page.
Click Save. Settings to save your changes,
or click Don't.Save.Settings to discard your
changes.
D-Link DWR-116 User Manual
Inbound Filter
41