Tecsun PL-390 Operation Manual page 12

Notes:
1. During ATS process in FM, MW / LW or SW (mode A),
pre-stored radio stations will be replaced automatically
by the new searched stations.
2. With ATS in SW (mode B), those existing memories will
not be replaced; all the newly found radio stations would
be stored in the blank memories addresses.
3. If there is too many interference in you surrounding or
many mirror/blank station being stored during ATS, you
should contract the telescopic antenna (FM & SW) or
rotate the radio for better location (MW & LW).
METHOD 2: MANUAL STORING STATON
1. Select band and tune to your desired station.
2. Press the [M] button with "preset" flashing
3. Press the [M] button again to store the station into
memory.
You can also wait for 3 seconds to auto store the station
into memory.
METHOD 3: SEMI-AUTO STORING STATION
While operating the "Auto Browse Station" function, you
can simply press on the [M] button to store the station into
memory to avoid storing unwanted stations and interfering
signals.
1. Press the [VF] button to switch into frequency mode.
2. Press & hold the [VF] button with "
auto browse from one station to another.
3. While tuning to your favor station, press the [M] button
with "PRESET " flashing to direct store the station into the
next available memory. The unit will keep on browsing
until you deactivate it by pressing on the [VF] button
again.
10
" advancing to
PL-390