Rangemaster Elan 110 User's Manual & Installation Instructions page 24

Fig.6-1
ArtNo.324-0005 Oven light bulb
Fig.6-2
Fig.6-3
E ect of hinge adjustment – exaggerated for clarity
Fig.6-4
Centre line of hinge pin
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
ArtNo.324-0007 Unscrewing the bulb cover
20
An oven light is not working
The bulb has probably burnt out. You can buy a
replacement bulb (which is not covered under the
warranty) from a good electrical shop. Ask for a 15 W –
230 V lamp, FOR OVENS. It must be a special bulb, heat
resistant to 300 °C (Fig.6-1).
Turn o the power at the circuit breaker.
Before removing the existing bulb, turn o the power
supply and make sure that the oven is cool. Open the
oven door and remove the oven shelves.
Unscrew the bulb cover by turning counter-clockwise.
It may be very sti (Fig.6-2). Taking care to protect your
ngers with a glove in case the bulb should shatter.
Screw in the new bulb; screw back the bulb cover. Turn
on the circuit breaker and check that the bulb now
lights.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted
to alter the angle of the door (Fig.6-3). Loosen the
bottom hinge xing screws and use the notch and a at
bladed screwdriver to move the position of the hinge to
set the hinge position (Fig.6-4).
Retighten the hinge screws.