Using The Setup Wizard - Huawei HG232f User Manual

www.4GSource.net
3 Configuration of Internet Access Parameters

3.2 Using the Setup Wizard

After logging in to the web-based configuration utility, you can use the setup wizard
provided by the utility to quickly configure the HG232f.
When you configure the HG232f for the first time, you can view the setup wizard page
after logging in to the utility. To configure the HG232f through the setup wizard:
If you have configured the HG232f before, the setup wizard page will not be displayed after
logging in to the web-based configuration utility. However, you can still click Setup Wizard in
the upper right corner to display the setup wizard page.
Step 1
Log in to the Web-based configuration utility.
Step 2 Set Connection Type and Internet access parameters (such as the Internet access type)
as described in Table 3-1, and then click Next.
If you can access the Internet with your computer before installing the HG232f, you can set the
Internet access type to that of the computer's current Internet access settings. In addition, when
you subscribe to an Internet access service, the network service provider informs you of the
Internet access type and Internet access method.
Table 3-1 Configuring the Internet access parameters
Scenario
You are a PPPoE user. The network
service provider has provided an account
and password used to access the Internet in
PPPoE dial-up mode.
You can access the Internet without the
PPPoE dial-up operation. The network
service provider's device assigns an IP
address to your computer automatically.
The network service provider has provided
the network parameter settings (such as a
fixed IP address, subnet mask, gateway,
and domain name server), and informed
you that you need to set the Internet access
parameters of your computer based on
these settings.
Your computer obtains an IP address from
the upstream device directly. The HG232f
allows all data through without any
processing.
Step 3
Set WLAN parameters, and then click Next.
Check the label on the HG232f's rear panel for the SSID and WLAN Key. The preceding
configuration needs to be performed only once. You can also configure the WLAN SSID and key
by choosing Basic > WLAN.
3-2
HG232f 300Mbps Wireless Router
Configuration
Select PPPoE as Connection Type,
and then set Account and Password.
Select DHCP as Connection Type.
Select Static IP as the Connection
Type, and then set the IP address,
Subnet mask, Default gateway,
Primary DNS, and Secondary DNS
based on the network parameter
settings provided by the network
service provider.
Select Bridge as Connection Type.
Issue 01 (2012-05-08)
User Guide