Assembling The Treadmill - CYBEX 600T Owner's Manual

Assembling the Treadmill

To ensure correct assembly of the treadmill, carefully follow these steps:
NOTE: In this manual the words "left" and "right" are from the treadmill user's point
1. Move the treadmill into position.
A. The shipping box has a small ramp at the front end of the treadmill base. After
removing the boxes, parts, and plastic wrapping from the top of the base, lift the back
end of the treadmill and roll it down the ramp.
B. Continue to lift the back of the base while you roll the treadmill to the location you
intend to leave it.
2. Pivot the treadmill into position.
A. Grasp the console and raise the console and uprights into position (they will pivot into
place). NOTE: The display cable that exits the bottom, left of the upright, is designed
to be held out of the way during installation; confirm that it is not pinched while raising
the unit.
3. Secure the handlebar.
A. Using a 1/2" wrench, secure the handlebar with two screws provided in bag 1. Be sure
to install the screws from the right. See Figure 2.
NOTE: The two screws on the handlebar are installed from the right. See Figure 2.
Figure 2
4. Secure the uprights.
A. Using a 1/2" wrench, secure the upright with six screws provided in bag 1.
5. Use a 1/2" wrench to tighten all eight screws at this time.
Page 5-4
Cybex 600T Treadmill Owner's Manual
of view.
Handlebar
Screws