CYBEX 600T Owner's Manual page 28

C. Remove the other side rail and set aside.
3. Check belt condition.
A. Run your hand under the belt on the top of the deck surface. If you notice any
excessive ridges, furrowing or cracks in the deck or if the deck feels very rough, the
surface may have worn down to a point where it could start to cause excessive wear
to the undersurface of the running belt. If belt needs replaced contact the nearest
authorized Cybex dealer or other competent repair service. See the "Running Belt"
section of the Service Manual for replacement information.
4. Replace the side rails and plastic end caps.
A. Slide the two side rails back on being sure to catch the rail guides.
B. Attach the plastic end caps with the Phillips screwdriver.
NOTE: Refer to "Running Belt" in the 600T Treadmill Service Manual for more
! CAUTION: Do not use a running belt made for a different model treadmill. The
Page 4-4
Cybex 600T Treadmill Owner's Manual
information. Contact Cybex Customer Service to order a Service Manual, parts,
or to locate the Cybex dealer nearest you.
belts are specific for each treadmill and may be torn up or cause
excessive current and damage the electronics if used in combination
with another deck.