Maintenance & Care; Machine Storage - Bissell 1210 Series User Manual

Maintenance & Care
machine care
For best results, a few simple steps can assure
your machine is well maintained after cleaning
is complete.
1. Turn power switch off. Unplug the machine
and wrap the power cord.
2. After emptying the 2-in-1 water tank, rinse it
with running hot tap water, taking care to clean
underneath and around the heavy duty bladder.
Clean out red lint screen prior to replacing tank.
Removable nozzle may be rinsed if necessary.
3. Replace the 2-in-1 water tank on the machine.
4. Any loose hair or debris can be pulled from
the brush roll and thrown away. see page 12 for
instructions on removing the brush roll.
5. Clean the ReadyTools dial assembly area by
following instructions in step 15 and 16 on page 9.
6. To clean attachments, remove from hose and
rinse in clean, running water. Dry before stor-
ing. Clean the hose by suctioning clean water
from the tap (taking care not to let the tank
overflow). before wrapping back on machine, lift
end of hose and stretch out to ensure all water is
cleared from hose. Refer to page 9, illustrations
11 and 12.
7. Wipe the machine's exterior with a soft cloth.
8. After carpet is dry, you may wish to vacuum
again to remove any leftover hair and fuzz the
deep cleaner may have brought to the carpet
surface.

machine storage

Put the unit away in a closet or basement for
the next use. store cleaner in a protected, dry
area. since this product uses water, it must not
be stored where there is a danger of freezing.
Freezing will damage internal components and
void the warranty.
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
www.bissell.com
Tip
» Let all parts
dry completely
before storing
800.237.7691
11