Bissell 1210 Series User Manual page 9

Operation
7. set the ReadyTools dial to the TOOls
setting. This will allow spray and suction from
the hose.
8. Attach the cleaning tool of your choice to the
end of the hose.
9. Clean by pressing the trigger to spray solu-
tion onto the area to be cleaned. slowly move
the tool back and forth over the soiled surface.
Release the trigger to suction dirty water.
Continue to clean in the area, working
in small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and rinse
tool(s) in clean, running water.
11. it is recommended that you suction clean
water from the tap to rinse out the hose. be
careful not to over-fill your tank.
12. before wrapping hose onto tool rack, lift
end of hose and stretch out to ensure all water
is cleared from hose.
13. Wrap flex hose around hose and cord rack.
14. empty 2-in-1 water tank and rinse out,
following instructions on page 8.
15. if the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the dial
may need to be cleaned. To clean, first remove
nozzle and locate screw that holds the diverter
assembly in place. With a Phillips screwdriver,
remove the screw and set aside.
16. Remove diverter assembly; hold under
running water making sure water flows through
and around the dial. Turn the dial about 10
times clockwise and 10 more times counter
clockwise. This should free up any debris.
17. Wipe diverter assembly with a soft cloth
and replace back on machine. Replace nozzle.
18. Return ReadyTools dial to FlOOR
CleANiNG setting.
7.
11.
15.
www.bissell.com
12.
16.
800.237.7691
9