Adjustment Of Flake Size - Hoshizaki F-800MAH(-C) Service Manual

2. ADJUSTMENT OF FLAKE SIZE

To adjust the flake size, change the direction of the Cutter Head on the top of the Auger,
according to the following procedures:
1) Remove the Bolt and the Cutter Head.
2) The Cutter Head has two holes, one for fine
flake and the other for coarse flake size. The
unit is shipped from the factory in the fine flake
position.
3) Place the Cutter Head so that the Pin on the top of the Auger fits into the selected hole.
4) Secure the Cutter Head by the Bolt.
COARSE
34
FINE