Hoshizaki F-450MAJ Quick Start Manual

Ice Machine
The icemaker and dispenser must be cleaned & sanitized at least twice a year.
Cleaning Prep:
1 Close the icemaker water supply line shut-off valve.
Remove the Front Panel, move the
2
to DRAIN. Make sure the
3
Allow the water system to drain completely. Remove the Front
and Top Panels, move the
4
Remove all ice from the ice storage bin and/or dispenser
ATTENTION! IF ON DISPENSER, turn off the dispenser power supply after dispensing
all the leftover ice.
Cleaning:
Front of
icemaker
Remove the Spout-to-Chute Strap
5
(includes Drip Guide on F-1501 and
larger), then remove the Spout.
Dilute Hoshizaki Scale Away with
6
warm water (see Table).
Cleaning Solution
Scale Away 9.6 fl. oz (0.29 l)
Warm Water 1.6 gal. (6.0 l)
Pour the cleaning solution over the
Extruding Head until the Evaporator
Assembly and Reservoir are full,
and the solution runs out through the
Overflow Hose.
Pour Solution into
Extruding Head
#51055 | 02.21.2018
Cleaning & Sanitizing
control switch
power switch is ON. Replace the Front Panel.
power switch to OFF.
Top
Right Side
Control Switch
Power Switch
Replace the Spout, Spout-to-Chute Strap, and Drip
Guide (if applicable) in their correct positions.
Allow the icemaker to soak for 10 minutes.
 continued on the back...
Tech Support: 1.800.233.1940
To Icemaker
Or Water Filter
SHUT OFF
.
Left Side Top Panel
Panel
Right Side
Front
Panel
F-450MAJ(-C)
FD-650MAH-C, MWH-C, MRH-C
F-801MAJ(-C), MWJ(-C)
F-1002MAJ(-C), MWJ(-C), MRJ(-C), MLJ
FD-1002MAJ-C, MRJ-C
F-1501MAJ(-C), MWJ(-C), MRJ(-C)
F-2001MWJ, MRJ/3(-C), MLJ
ATTENTION!
DO NOT leave icemaker
unattended when panels are off
AMMONIA
Cleaners
Sanitizing:
• Dilute 5.25% chlorine
‡
bleach with warm water
(see Table below)
Sanitizing Solution
Bleach 9.6 fl. oz (0.29 l)
Warm Water 1.6 gal. (6.0 l)
Use bleach without additives.
‡
• Remove the front and top
panels
• Move the power switch to OFF
Panel
• Remove the spout-to-chute
strap
(includes drip guide on F-1501
and larger)
• Remove the spout
• Pour the sanitizing solution
over the extruding head until
the evaporator assembly and
reservoir are full, and the
solution runs out the overflow
hose
• Replace the spout, spout-
to-chute strap, and drip
guide (if applicable) in their
correct positions.
• Allow the icemaker to sit for
10 minutes before operation
• Move the control switch to
ICE
• Move the power switch to ON
• Replace the panels in their
correct positions
• Make ice using the solution until
the icemaker stops making ice
15
16
17
16
17
18
Page 1