Adjustment Of Flake Size; Adjustment Of Cubelet Size - Hoshizaki F-1500MAH Service Manual

2. Adjustment of Flake Size

To adjust the flake size, change the number of the cutter heads on the top of the auger,
according to the following procedures:
1) Remove the bolt.
2) Take off the upper cutter head of the two (coarse flakes) or set the upper cutter head on
the lower (fine flakes). The unit is shipped from the factory with two cutter heads.
FINE COARSE
[two cutter heads] [one cutter head]
3) Secure the cutter head(s) with the bolt.

3. Adjustment of Cubelet Size

Cubelet size is not adjustable.
44