Table of Contents
Advertisement
NOTE: For 802.11b and 802.11g mode, the signals can be transmitted
only by antenna 1 (The antenna on the right side of the rear panel).
For 802.11n mode: The router is operating in a 2T2R Spatial
Multiplexing MIMO configuration. Two (2) antennas are for signal
transmitting and two (2) antennas are for signal receiving.
ESSID (2):
Channel Number (3):
Associated Clients (4): Click 'Show Active Clients' button, then an "Active Wireless
After you finish these wireless settings, please click 'Apply' button, button,
and the following message will be displayed on your web browser:
This is the name of wireless router. You can type any
alphanumerical characters here, maximum 32 characters.
ESSID is used to identify your own wireless router from others
when there are other wireless routers in the same area. Default
SSID is 'Hawking_300N', it's recommended to change default
ESSID value to the one which is meaningful to you, such as,
'myhome', 'office_room1', etc.
Please select a channel from the dropdown list of 'Channel
Number', available channel numbers are 1 to 13 for European
countries, 1 to 11 for USA. You can choose any channel number
you want to use, and almost all wireless clients can locate the
channel you're using automatically without any problem.
However, it's still useful to remember the channel number you
use, as some wireless clients support manual channel number
selecting, and this would help in certain scenarios when there
are radio communication conflicts.
Client Table" will pop up. You can see the status of all active
wireless stations that are connecting to the access point.
80
Advertisement
Table of Contents
