Maintenance; General; Table; Bearings - Grizzly G1019 Instruction Manual

SECTION 7: MAINTENANCE

General

Regular periodic maintenance on your Model
G1019 Bandsaw will ensure its optimum perfor-
mance. Make a habit of inspecting your bandsaw
each time you use it. Check for the following con-
ditions and repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Damaged V-belt.
5. Any other condition that could hamper the
safe operation of this machine.
Always perform any maintenance with the power
off and the machine unplugged.

Table

The table and other non-painted surfaces on the
Model G1019 should be protected against rust
and pitting. Wiping the saw clean after every use
ensures that moisture from wood dust isn't
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron
surfaces. The wax provides a layer of protection,
as well as reducing friction between lumber and
the table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that's being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it's 100% Carnauba wax.
-32-

Bearings

Since all bearings are shielded and permanently
lubricated, no maintenance is required on them. If
after a period of time you notice a distinct noise or
rumble coming from a shielded bearing, or the
bearing journal is hot to the touch after use, it will
be time to replace the shielded bearing assem-
bly(s). Please contact our Customer Service num-
ber to order replacement bearings or to make
arrangements to send your bandsaw back for ser-
vice.

V-Belt

Inspect V-belt regularly for tension and wear.
Replace when necessary. Check pulleys to
ensure that they are properly aligned and secure-
ly tightened. See "Motor Assembly" instructions
for proper tension and pulley alignment proce-
dures.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
G1019 14'' Bandsaw