Adjustments; Location Of Controls - Grizzly G1019 Instruction Manual

SECTION 5: ADJUSTMENTS
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
G1019 14'' Bandsaw
Keep clothing rolled up
and out of the way of
machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.

Location Of Controls

General control and adjustment locations are
shown in Figure 23 and are described below.
A
C
A
B
Figure 23. Location of controls.
A. These two knobs secure the upper and
lower wheel covers. The covers are only
opened to change a blade or make an
adjustment to blade tracking.
B. This is the push button switch that controls
the power to the motor.
C. This knob locks the rip fence in position.
D. These trunnion knobs are used to lock the
table in position.
E. The miter gauge slides in the milled groove
in the table and can be set at any angle
between 45° left and 45° right. Use the
miter gauge for crosscutting and miter-cut-
ting.
E
D
-19-