Grizzly G1019 Instruction Manual page 13

2. Stand the panels up so the rubber feet are
on the floor. Attach two cross braces to one
of the side panels using (4)
riage bolts, flat washers and hex nuts pro-
vided. Next, attach the other side panel to
the cross braces already mounted. See
Figure 4. Note: Do not tighten any fasten-
ers at this time.
Figure 4. Attach cross braces.
3. Now, turn the stand over and attach the
motor support plate using (4)
hex bolts, (8) washers and (4) hex nuts. See
Figure 5.
Motor
Support
Plate
Figure 5. Install motor support plate.
G1019 14'' Bandsaw
1 ⁄ ''-20 x 1 ⁄ '' car-
4 2
Cross Braces
5 ⁄ ''-18 x 3 ⁄ ''
16 4
4. Turn the stand right side up and attach the
motor mount plate to the motor mount sup-
port plate using (4)
(8) flat washers and (4) hex nuts. See
Figure 6.
Motor
Mount
Plate
Figure 6. Add motor mount plate.
5. Mount the double bend brace to the motor
mount plate. Use (2)
(8) flat washers and (2) hex nuts. See
Figure 7.
Double
Bend
Brace
Figure 7. Mount double bend brace.
5 ⁄ "-18 x 3 ⁄ " hex bolts,
16 4
5 ⁄ ''-18 x 3 ⁄ '' hex bolts,
16 4
-11-