4.6. BIOS FEATURES SETUP
Virus Warning
If it is set to enable, the category will flash on the screen when there is
any attempt to write to the boot sector or partition table of the hard disk
drive. The system will halt and the following error message will appear in
the mean time. You can run anti-virus program to locate the problem.
l
Suspend Mode Option
The default value is PowerOn Suspend
Suspend to Disk
VGA Active Monitor
The default value is Disabled.
Disabled
Enabled
Soft-off by PWR-BTTN
The default value is Instant-Off.
Instant-off
Delay 4 Sec.
Resume by Alarm
The default value is Disabled.
Disabled
Enabled
If the default value is Enabled.
Date ( of Month) Alarm :
Time ( hh: mm: ss) Alarm :
IRQ [3-7,9-15], NMI
The default value is Enabled.
Disabled
Enabled
Figure 4.3: BIOS Features Setup
Set the system to Suspend to Disk mode
Disable monitor VGA activity.
Enable monitor VGA activity.
Soft switch ON/OFF for POWER ON/OFF
Soft switch ON 4sec. for POWER OFF.
Disable this function.
Enable alarm function to POWER ON system.
Disable this function.
Enable monitor IRQ [3-7,9-15] for Green event.
0~31
(0~23) : (0~59) : (0~59)
BIOS Configuation