Using The Digital Wide Function (Digital Wide Mode) - Pentax X-5 Operating Manual

6
Press the shutter release button halfway.
The focus frame (or face detection frame) on the display turns green
when the camera focuses on the subject at the correct distance.
To use the flash, press the b button to pop up the flash (p.84).
7
Press the shutter release button fully.
The picture is taken.
• The number of recorded pixels is fixed at h.
• By default, three frames are built-in to the camera. These frames are
not deleted even if the built-in memory is formatted. The CD-ROM
supplied with the camera contains optional frames. To save the frames
into the built-in memory, copy the files from the CD-ROM (p.152).
• In N mode, you cannot display "Grid Display" by pressing the 3
button.
Adding a Frame to a captured image 1p.150
Using the Digital Wide Function (Digital Wide
Mode)
In X (Digital Wide) mode, you can stitch two vertical images captured
with this camera into a single frame up to approx. 17 mm coverage (35
mm film equivalent).
1
Use the four-way controller (2345) to select X
from the Capture Mode Palette.
+
3
73