Resetting The Microprocessor; Specifications - Denon AVR-E400 Owner's Manual

Resetting the microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.
Note that when the microprocessor is reset, all the settings are reset to their default values.
X SOURCE SELECT 0
SOURCE SELECT 1
1
X
Turn off the power using .
2
X
Press while simultaneously pressing
1.
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
DVD
SOURCE SELECT SOURCE SELECT
0 and

Specifications

n Audio section
• Power amplifier
Rated output: Front:
Center:
Surround:
Surround back:
Output connectors: 6 – 16 Ω/ohms
• Analog
Input sensitivity/Input impedance:
200 mV/47 kΩ/kohms
Frequency response: 10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)
S/N: 100 dB (IHF–A weighted, DIRECT mode)
n Tuner section
(Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10 –15 W)
Receiving Range: 87.5 MHz – 107.9 MHz
Usable Sensitivity: 1.2 μV (12.8 dBf)
50 dB Quieting Sensitivity:
MONO
S/N :
MONO
STEREO
Total harmonic Distortion: MONO
STEREO
n General
Power supply: AC 120 V, 60 Hz
Power consumption: 460 W
Power consumption in standby mode: 0.1 W
Power consumption in CEC standby
mode:
0.5 W
Power consumption in network
standby mode: 2.7 W
For purposes of improvement, specifications and design are subject to change without notice.
149
90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)
125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
[FM]
520 kHz – 1710 kHz
18 μV
2.8 μV (20.2 dBf)
70 dB (IHF–A weighted, DIRECT mode)
67 dB (IHF–A weighted, DIRECT mode)
0.7 % (1 kHz)
1.0 % (1 kHz)
[AM]